Internal assemblies
TIP: For clarity, some photos in this chapter show components removed that would not be removed to
service the product. If necessary, remove the components listed at the beginning of a procedure before
proceeding to service the product.
Stapler assembly
Before proceeding, remove the following components:
●
Stapler cover. See
Stapler cover on page 85.
Remove the stapler assembly
▲
Disconnect one connector (callout 1), remove two screws (callout 2), and then remove the stapler
assembly.
Figure 1-212 Remove the stapler assembly
1
2
ENWW
Removal and replacement procedures
147
To Next Page
Loading...