DC controller PCA and tray
Before proceeding, remove the following components:
●
Toner-collection unit. See
Toner-collection unit on page 15.
●
Formatter PCA. See
Formatter PCA on page 17.
●
Right-rear cover. See
Right-rear cover on page 90.
●
Left cover. See
Left cover on page 92.
●
Rear-upper cover. See
Rear-upper cover on page 95.
●
Rear cover. See
Rear cover on page 98.
●
Interconnect board (ICB). See
Interconnect board (ICB) on page 148.
Remove the DC controller PCA and tray
CAUTION: ESD-sensitive part.
TIP: To access components behind the DC controller PCA, remove the PCA and the sheet-metal tray
together. Disconnect all of the connectors on the PCA, and then remove five screws and the bracket,
see
Figure 1-216 Remove the DC controller PCA and tray (1 of 4) on page 150 and Figure 1-219
Remove the DC controller PCA and tray (4 of 4) on page 152.
NOTE: To locate DC controller connector locations, see DC controller PCA on page 8.
1. Remove one screw (callout 1), and then remove the sheet-metal bracket (callout 2).
Figure 1-216 Remove the DC controller PCA and tray (1 of 4)
2
1
150 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...