Low-voltage power supply (LVPS)
Before proceeding, remove the following components:
●
Toner-collection unit. See
Toner-collection unit on page 15.
●
Formatter PCA. See
Formatter PCA on page 17.
●
Right-rear cover. See
Right-rear cover on page 90.
●
Left cover. See
Left cover on page 92.
●
Rear-upper cover. See
Rear-upper cover on page 95.
●
Rear cover. See
Rear cover on page 98.
●
Interconnect board (ICB). See
Interconnect board (ICB) on page 148.
NOTE: If you are removing the power supply for internal product access, it is recommended that
you leave the ICB installed on the power supply assembly.
Remove the LVPS
CAUTION: ESD-sensitive part.
NOTE: The formatter cage is attached to the LVPS. Both components are removed as an assembly,
and then the formatter cage is removed from the LVPS.
1. Disconnect six connectors (callout 1; J100, J101, J143 on the DC controller PCA).
NOTE: To locate DC controller connector locations, see DC controller PCA on page 8.
Figure 1-220 Remove the LVPS (1 of 8)
1
ENWW
Removal and replacement procedures
153
To Next Page
Loading...