Toner-collection sensor
Before proceeding, remove the following components:
●
Toner-collection unit. See
Toner-collection unit on page 15.
●
Left cover. See
Left cover on page 92.
Remove the toner-collection sensor
1. Remove five screws (callout 1), and then remove the sheet-metal plate (callout 2).
NOTE: Release the small sheet-metal plate (callout 3) to allow access to the larger sheet-metal
plate behind it. Leave the smaller plate attached to the chassis.
Figure 1-237 Remove the toner-collection sensor (1 of 4)
2
1
3
ENWW
Removal and replacement procedures
163
To Next Page
Loading...