5. While pushing down on the paper entrance guide (callout 1), use a flat blade screwdriver to press
in on the hinge pin (callout 2) and release it from the product. Rotate the assembly
counterclockwise away from the product to remove it.
Figure 1-256 Remove the lower pickup guide (4 of 4)
2
1
Reinstall the lower pickup guide
▲
Insert the front pin of the assembly into the hole at the front of the chassis. Slightly press down on
the rear hinge pin and insert it into the hole at the rear of the chassis. Rotate the guide toward the
product until the green knobs snap back into place. Tighten the screw on the paper entrance
guide.
176 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...