Registration assembly
Before proceeding, remove the following components:
●
Toner-collection unit. See
Toner-collection unit on page 15.
●
Intermediate transfer belt (ITB). See
Intermediate transfer belt (ITB) on page 34.
●
Right-rear cover. See
Right-rear cover on page 90.
●
Left cover. See
Left cover on page 92.
●
Rear-upper cover. See
Rear-upper cover on page 95.
●
Rear cover. See
Rear cover on page 98.
●
Registration density (RD) sensor assembly. See
Registration density (RD) sensor assembly
on page 177.
TIP: Removing the RD sensor assembly makes it much easier to reinstall the registration
assembly.
●
Power-supply fan and fan duct. See
Power-supply fan and fan duct on page 181.
●
Secondary transfer assembly. See
Secondary transfer assembly on page 171.
Remove the registration assembly
NOTE: If a replacement registration assembly is installed, you must use the control-panel menus to
reset the registration-roller count.
1. Remove two screws (callout 1).
Figure 1-267 Remove the registration assembly (1 of 8)
1
184 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...