HP LASERJET M575 - Main-Drive Assembly Replacement

Tray-pickup assembly
Before proceeding, remove the following components:
●
Toner-collection unit. See
Toner-collection unit on page 15.
●
Formatter PCA. See
Formatter PCA on page 17.
●
Right-rear cover. See
Right-rear cover on page 90.
●
Left cover. See
Left cover on page 92.
●
Rear-upper cover. See
Rear-upper cover on page 95.
●
Rear cover. See
Rear cover on page 98.
●
Interconnect board (ICB). See
Interconnect board (ICB) on page 148.
●
Low-voltage power supply (LVPS). See
Low-voltage power supply (LVPS) on page 153.
●
Registration density (RD) sensor assembly. See
Registration density (RD) sensor assembly
on page 177.
●
High-voltage power supply lower. See
High-voltage power supply lower on page 189.
●
Tray-pickup drive assembly. See
Tray-pickup drive assembly on page 197.
Remove the tray-pickup assembly
1. Release one tab (callout 1), and then remove the gear (callout 2).
Figure 1-298 Remove the tray-pickup assembly (1 of 3)
2
1
204 Chapter 1 Removal and replacement ENWW