Drum motor 1
Before proceeding, remove the following components:
●
Toner-collection unit. See
Toner-collection unit on page 15.
●
Right-rear cover. See
Right-rear cover on page 90.
●
Left cover. See
Left cover on page 92.
●
Rear-upper cover. See
Rear-upper cover on page 95.
●
Rear cover. See
Rear cover on page 98.
●
Interconnect board (ICB). See
Interconnect board (ICB) on page 148.
●
DC controller. See
DC controller PCA and tray on page 150.
●
Low-voltage power supply (LVPS). See
Low-voltage power supply (LVPS) on page 153.
●
High-voltage power supply upper. See
High-voltage power supply upper on page 221.
Remove the drum motor 1
▲
Disconnect one connector (callout 1), remove four screws (callout 2), and then remove the motor.
Figure 1-331 Remove the drum motor 1
2
1
ENWW
Removal and replacement procedures
225
To Next Page
Loading...