Reinstall the main-drive assembly
1. Remove the bracket (callout 1), two guides (callout 2), and the developing-disengagement motor
(callout 3).
Install the bracket and guides on the replacement main-drive assembly.
NOTE: Do not install the developing-disengagement motor on the assembly (this motor must be
removed from the assembly to align the main-drive cams).
Figure 1-341 Reinstall the main-drive assembly (1 of 11)
3
2
1
2. Locate the cams (callout 1) on the back side of the assembly.
Figure 1-342 Reinstall the main-drive assembly (2 of 11)
1
ENWW
Removal and replacement procedures
233
To Next Page
Loading...