5. Disconnect one connector (callout 1), remove two screws (callout 2), and then carefully lift the
assembly (callout 3) off of the product to remove it.
CAUTION: A solenoid arm (on the right side) and a spring (on the left side) on the assembly
are not captive. Do not lose the solenoid arm or spring when you remove the assembly. If the
solenoid arm or spring become dislodged, see
Reinstall the delivery assembly on page 248.
Figure 1-363 Remove the delivery assembly (5 of 5)
1
3
2
ENWW
Removal and replacement procedures
247
To Next Page
Loading...