Separation roller (Tray 2)
CAUTION: Do not touch the spongy roller surface unless you are replacing the roller. Skin oils on the
roller can cause paper pickup problems.
NOTE: Remove the Tray 2 if not already removed for service. See Tray 2 and 3 on page 23.
Remove two screws (callout 1), and then remove the separation roller assembly (callout 2).
Figure 1-34 Remove the separation roller (Tray 2)
2
1
CAUTION: To install a self-tapping screw, first turn it counterclockwise to align it with the thread
pattern, and then carefully turn it clockwise to tighten. Do not overtighten. If a self-tapping screw-hole
becomes stripped, repair the screw-hole or replace the affected assembly.
ENWW
Removal and replacement procedures
31
To Next Page
Loading...