20 Chapter 1 Setting up ENWW
15 Locate the phone cord that is included with the fax accessory kit.
Connect one end of the phone cord into the fax accessory phone
jack that is on the formatter. Push the connector until you hear a
click.
Figure 1-25 Connecting the phone cord
CAUTION Be sure to connect the phone line to the fax accessory port, which is
near the top of the formatter. Do not connect the phone line to the
HP Jetdirect LAN port, which is nearer the bottom of the formatter.
16 Connect the other end of the phone cord into the phone jack on
the wall. Push the connector until you hear a click or until the
connector is securely seated. Because there are different types of
connectors, depending on the country/region, the connector
might make an audible click when connected or might not make
an audible click.
Verifying fax operation
When the fax accessory is installed and operating correctly, the fax
icon displays on the MFP control panel, see Figure 1-26. If the fax
accessory has just been installed but has not been configured, the
fax icon is grayed-out with Not Configured written across it. If this
occurs, the fax accessory needs to be configured, see “Making
required fax settings” on page 21.
To Next Page
Loading...
