ENWW Making required fax settings 23
English
1 On the control panel, press the Menu button to display the main
menu.
2 Touch FAX to display the fax menu.
3 Touch FAX SETUP REQUIRED to display the required settings
menu.
4 Touch DATE/TIME to display the settings.
5 Select the date format and then enter the date.
6 Select the time format and then enter the time.
7 Touch OK to accept the settings.
To set the location
The location setting identifies the country/region where the MFP/fax
accessory is located. This setting also sets the date/time format
and minimum/maximum rings-to-answer range for the country/region.
Because this setting is a legal requirement in some countries/regions,
it must be set for the fax accessory to operate. If this is the first time
you are powering up the printer, you will be prompted for this
information.
When configuring the required fax settings for the location setting,
some countries/regions are supported, but do not have an entry in the
location setting menu list. These additional countries/regions can be
supported by selecting another, alternate country/region from the
location settings list. The following table lists additional supported
countries/regions and an acceptable alternate country/region to
select to support that country/region.
Table 1: Location (country/region) setting support additions
To support this
country/region
Select this country/region from the location setting
list
Estonia Norway, Sweden, or Russian Federation
Iceland Denmark, Norway, or Sweden
Latvia Norway, Sweden, or Russian Federation
Liechtenstein Austria or Switzerland
Lithuania Norway, Sweden, or Russian Federation
Morocco Spain
Slovenia Hungary or Poland
To Next Page
Loading...
