HP LaserJet MFP - Configuration; Introduction; Remote fax configuration; Setting billing codes

ENWW Introduction 45
English
3
Configuration
Introduction
This chapter describes the configuration settings for the MFP fax
accessory that you access through the fax menu on the control panel.
In addition to the control panel, you can access these settings
through remote configuration tools, as described below.
Note The following fax settings are described in Chapter 1 and are not
included here. For information about these settings, see Chapter 1.
- Canceling faxes
- Setting the date and time
- Setting the location
- Setting the header
Remote fax configuration
In addition to the MFP control panel, you can configure the fax
accessory remotely using various software tools. Because the MFP
contains an embedded Web server (EWS), you can configure the fax
accessory across the Web using either a Web browser or HP Web
Jetadmin (WJA). In addition, you can configure the fax accessory
across the network with a network-connected PC using the HP MFP
Digital Sending Software Configuration Utility (DSS). These tools
provide access to most of the fax accessory configuration settings
available from the MFP fax menu, described in this document.