ENWW Setting JBIG compression mode 49
English
3 Touch FAX SETUP OPTIONAL to display the optional
setup items.
4 Touch ERROR CORRECTION MODE to display the settings.
5 Touch ON (default) to enable error correction mode, or touch OFF
to disable correction mode.
Setting JBIG compression mode
Enabling JBIG compression can reduce phone call charges by
reducing fax transmission time and is, therefore, the preferred setting.
However, JBIG may cause compatibility problems when
communicating with some older fax machines, in which case you
may need to disable it.
Note JBIG compression only works when both the sending and receiving
machines have JBIG compression.
To enable or disable JBIG compression, perform the following steps.
1 On the control panel, press the Menu button to display the main
menu.
2 Touch FAX to display the fax menu.
3 Touch FAX SETUP OPTIONAL to display the optional setup
items.
4 Touch JBIG COMPRESSION to display the settings.
5 Touch ON (default) to enable JBIG compression, or touch OFF to
disable JBIG compression.
Setting outgoing fax resolution
The outgoing fax resolution setting determines the maximum
resolution supported by the receiving fax. The fax accessory uses
the highest possible resolution, limited by this setting, and the
maximum resolution of the receiving fax.
Note Faxes wider than 21.25 cm (8.5 inches), will automatically be sent using
standard or fine, to reduce phone time.
To set the resolution, perform the following steps.
1 On the control panel, press the Menu button to display the main
menu.
2 Touch FAX to display the fax menu.
3 Scroll down and touch FAX SEND.
To Next Page
Loading...
