50 Chapter 3 Configuration ENWW
4 Touch DEFAULT RESOLUTION to display the resolution settings.
5 Touch STANDARD (200 x 100 dpi, default), FINE (200 x 200 dpi),
or SUPERFINE (300 x 300 dpi) to select the resolution.
Note The default resolution setting is a lower dpi than previous MFP model
default resolutions settings. For example, previous MFP models had a
default resolution of FINE (200 x 200 dpi).
Note The higher the resolution, the longer the transmission time required.
Setting the overlay header (outgoing faxes)
The overlay header consists of the date, time, company name, phone
number, and page number and is printed at the top of the page on
outgoing faxes. This setting determines whether the header is
appended to the top of the page or is printed as an overlay. If the
header is appended to the top of a page, it moves page data down
which can result in data at the bottom of a page being pushed to
another page, possibly printing an additional page. If the header is
printed as an overlay, it does not push any page data, but may print
over data at the top of the page.
Note When fax forwarding is enabled, the overlay header is always appended
to the top of the page, even if overlay is enabled.
To select how the header is printed, perform the following steps.
1 On the control panel, press the Menu button to display the
main menu.
2 Touch FAX to display the fax menu.
3 Scroll down and touch FAX SEND.
4 Touch OVERLAY HEADER to display the header settings.
5 Touch YES to print the header as an overlay, or touch NO
(default) to append the header to the top of the page.
To Next Page
Loading...
