HP LaserJet MFP - Setting redial rules; Faxing (advanced); Secure settings; Changing your PIN

ENWW Setting dialing mode 51
English
Setting dialing mode
The dialing mode setting sets the type of dialing used, either tone
(touch-tone phones) or pulse (rotary-dial phones).
To set dialing mode, perform the following steps.
1 On the control panel, press the Menu button to display the
main menu.
2 Touch FAX to display the fax menu.
3 Scroll down and touch FAX SEND. Use the down arrow key to
scroll to DIALING MODE.
4 Touch DIALING MODE to display the dialing mode settings.
5 Touch TONE (default) to set the fax for tone dialing, or touch
PULSE to set the fax for pulse dialing.
Setting redial rules
To set redial-on-busy
The redial-on-busy setting selects the number of times (0 through 9)
the fax accessory redials a number when it is busy. The interval
between retries is set by the Redial Interval setting.
1 On the control panel, press the Menu button to display the
main menu.
2 Touch FAX to display the fax menu.
3 Scroll down and touch FAX SEND.
4 Touch REDIAL ON BUSY to display the redial-on-busy setting
screen.
5 Use the up and down arrows to select the number (default=3),
and then touch OK.
To set redial-on-no-answer
The redial-on-no-answer setting selects the number of times the fax
accessory redials if the number dialed does not answer. The number
of retries is either 0 to 1 (used in the U.S.) or 0 to 2, depending on the
country/region setting. The interval between retries is set by the redial
interval setting.
1 On the control panel, press the Menu button to display the
main menu.
2 Touch FAX to display the fax menu.