52 Chapter 3 Configuration ENWW
3 Scroll down and touch FAX SEND.
4 Scroll down and touch REDIAL ON NO ANSWER to display the
setting screen.
5 Use the up and down arrows to select the number (default=0),
and then touch OK.
To set redial interval
The redial interval setting selects the number of minutes between
retries if the number dialed is busy or not answering.
1 On the control panel, press the Menu button to display the
main menu.
2 Touch FAX to display the fax menu.
3 Scroll down and touch FAX SEND.
4 Scroll down and touch REDIAL INTERVAL to display the setting
screen.
5 Use the up and down arrows to select the number (1 through
5 minutes; default=5), and then touch OK.
Note You may observe a redial message on the control panel when both the
Redial-on-Busy and Redial-on-No-Answer settings are set to off.
This occurs when the fax accessory dials a number, establishes a
connection, and then loses the connection. As a result of this error
condition, the fax accessory performs two automatic redial attempts
regardless of the redial settings (the first one at 26,400 bps and, if that
fails, a second one at 14,400 bps). During this redial operation, the fax
accessory displays a message on the control panel that indicates that
a redial is in progress.
Setting dial tone detection
The detect dial tone setting determines whether the fax checks for a
dial tone before sending a fax.
To enable or disable dial tone detection, perform the following steps.
1 On the control panel, press the Menu button to display the
main menu.
2 Touch FAX to display the fax menu.
3 Scroll down and touch FAX SEND.
4 Scroll down and touch DETECT DIAL TONE to display the detect
dial tone settings.
To Next Page
Loading...
