HP LaserJet MFP - Setting up; Introduction

ENWW Introduction 1
English
1
Setting up
Introduction
The HP LaserJet MFP Analog Fax Accessory 300 enables the
HP multifunction product (MFP) to function as a standalone analog
fax machine.
This guide describes the fax functions of this product and can help
you complete the following tasks:
● Install/replace the fax accessory in the MFP
● Perform initial setup configuration
● Send faxes
● Configure fax settings
● Set advanced fax features
● Access fax logs and reports
● Troubleshoot problems
In addition, this guide provides information on product specifications
and regulatory information.
Note In addition to the analog fax feature, the MFP also supports LAN faxing.
LAN faxing is managed by the HP MFP Digital Sending Software
Configuration Utility which is a separate product and is not covered in
this document. For information about LAN faxing, see the HP MFP
Digital Sending Software User Guide or the HP MFP Digital Sending
Software Support Guide. If both the analog fax accessory and the LAN
fax are installed, only one fax can be enabled at a time.
You should save this guide so that you can refer back to instructions
on specific fax features.
Note If the MFP did not come with the fax accessory installed, you need to
install it as described in this chapter.