HP LaserJet MFP User Manual

2 Chapter 1 Setting up ENWW
Note If the MFP came with the fax accessory installed, you need to remove
the fax connection cover, connect the phone cord, and then perform
the initial fax configuration that is also described in this chapter. The
fax connection cover is located on the phone connector on the formatter
rear panel.
Parts included with the fax accessory
The following components are included with the fax accessory:
● Fax guide (this document)
● Fax accessory hardware card
● Phone cord(s) (cords vary depending on the country/region)
Figure 1-1 HP LaserJet MFP Analog Fax Accessory 300 contents
Installing the fax accessory
This section describes installing the hardware fax accessory card into
the MFP. Procedures are provided for:
● HP LaserJet 9040/9050mfp
● HP LaserJet 4345mfp
● HP LaserJet 4730mfp
Select the procedure for your MFP.
The HP LaserJet MFP Analog Fax Accessory 300 is also supported
in the HP LaserJet 9500mfp, however, the fax accessory is
pre-installed in the HP LaserJet 9500mfp. For information about
installing or replacing the fax accessory in the HP LaserJet 9500mfp,
refer to the HP LaserJet 9500mfp User Guide.

HP LaserJet MFP Specifications

General

Brand	HP
Model	LaserJet MFP
Category	Fax Machine
Language	English