Control panel message Description Recommended action
20-INSUFFICIENT MEMORY
alternates with
To continue press
The device has received more data from the
computer than fits in available memory.
1. Press to continue printing.
NOTE: Data will be lost.
2. Reduce the complexity of the print job to
avoid this error.
3. Adding memory to the device may allow
printing of more complex pages.
21 PAGE TOO COMPLEX
alternates with
To continue press
The page-compression process is too slow
for the device. Some data may be lost on the
page.
1. Press to see step-by-step
information.
2. To print the job with some data loss,
press
to exit the message, and then
press
. If data is lost, simplify the
page content to reduce its complexity.
3. To exit, press
.
22-EIO X BUFFER OVERFLOW
alternates with
To continue press
For devices with an EIO device only.
The device EIO card in slot X has overflowed
its I/O buffer during a busy state.
1. Press to continue printing.
NOTE: Data will be lost.
2. If the message persists, contact
HP Support.
22-EMBEDDED I/O BUFFER OVERFLOW The embedded HP Jetdirect print server
buffer has overflowed during a busy state.
1. Press to continue printing.
NOTE: Data will be lost.
2. If the message persists, contact
HP Support.
22-PARALLEL I/O BUFFER OVERFLOW
alternates with
To continue press
The device parallel buffer has overflowed
during a busy state.
1. Press to continue printing.
NOTE: Data will be lost.
2. If the message persists after exiting
Help, contact HP Support.
22-SERIAL I/O BUFFER OVERFLOW
alternates with
To continue press
The device serial buffer has overflowed
during a busy state.
1. Press to continue printing.
NOTE: Data will be lost.
2. If the message persists, contact
HP Support.
22-USB I/O BUFFER OVERFLOW
alternates with
To continue press
The device's USB buffer has overflowed
during a busy state.
1. Press to continue printing.
NOTE: Data will be lost.
2. If the message persists, contact
HP Support.
40 BAD SERIAL TRANSMISSION
alternates with
To continue press
A serial data error (parity, framing, or line
overrun) has occurred while the device was
receiving data.
1. Press to continue printing.
NOTE: Data will be lost.
2. If the message persists, contact
HP Support.
ENWW Error codes 43
HP LJ P3005 Series
To Next Page
Loading...
