8. Remove three screws with washers (callout 1), and then remove the engine controller PCA (callout
2).
Figure 1-146 Remove the engine controller PCA (8 of 8)
2
1
Reinstall the engine controller PCA
NOTE: Follow these steps to correctly install the transfer-wire harness.
1. Set the ground spring (callout 1) on the transfer-wire harness (callout 2).
Figure 1-147 Reinstall the engine controller PCA (1 of 4)
2
1
98 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...