Post-service test
Perform the following test to verify that the repair or replacement was successful.
Print-quality test
1. Verify that you have completed the necessary reassembly steps.
2. Make sure that the tray contains clean, unmarked paper.
3. Attach the power cord and interface cable or interface cables, and then turn on the product.
4. Verify that the expected startup sounds occur.
5. Print a configuration page, and then verify that the expected printing sounds occur.
6. Print a demo page, and then verify that the print quality is as expected.
7. Send a print job from the host computer, and then verify that the output meets expectations.
8. Make a copy from the flatbed glass, and then verify that the output meets expectations.
9. Make a copy from the ADF, and then verify that the output meets expectations (HP LaserJet
Professional M1210 MFP series only).
10. Clean the outside of the product with a damp cloth.
ENWW Post-service test 5
To Next Page
Loading...