●
Touch the OK button to confirm that you want the pick roller to rotate.
●
Remove the power cord, without turning off the power using the power switch, and then
remove the interface cable.
NOTE: If the power to the product is turned off using the power switch, the pick roller will
rotate to the parked position.
2. Remove the cassette assembly, and then carefully place the product front-side up.
NOTE: Debris can scratch or damage the back of the product. Before you place the product
front-side up, remove any debris from the work surface. If possible, set the product on a clean, dry
cloth to prevent scratching and damage.
3. Release the two black plastic locking tabs and remove the pick roller.
Figure 1-3 Remove the pickup roller
ENWW
Removal and replacement procedures
9
To Next Page
Loading...