Separation roller
CAUTION: Do not touch the spongy roller surface unless you are going to replace the roller. Human
skin oils that contact the roller can cause paper pickup problems.
1. Remove cassette (if installed), and then carefully place the product front-side up.
NOTE: Debris can scratch or damage the back of the product. Before you place the product
front-side up, remove any debris from the work surface. If possible, set the product on a clean, dry
cloth to prevent scratching and damage.
2. Carefully release the roller cover and rotate it down and away from the roller.
Reinstallation tip Make sure that this cover snaps into place over the roller when the roller
and holder are reinstalled.
Figure 1-4 Remove the separation roller (1 of 2)
10 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...