●
Tape the wire-harness (callout 2) to the sheet-metal frame (callout 3) so that it will not catch on
internal components as the ITB (callout 1) is installed.
With the ITB partially installed, feed the wire-harness through the opening in the chassis. Finish
installing the ITB.
WARNING! Do not place the tape where it can make contact with or adhere to the transfer belt
(callout 1). Tape or tape residue on the transfer belt will cause print-quality problems.
NOTE: Remove all of the tape and tape residue after installing the ITB.
Figure 1-64 Reinstall the ITB (2 of 2)
23
1
ENWW
Removal and replacement procedures
55
To Next Page
Loading...