Reinstall the ITB
Use the following guidelines when you install the ITB.
●
WARNING! The lower sheet-metal portion of the ITB frame (callout 1) can be easily bent. Avoid
handling the ITB by this part of the sheet-metal frame.
Figure 1-63 Reinstall the ITB (1 of 2)
1
●
When handling the ITB, always hold it using the hard plastic portions of the assembly.
CAUTION: Avoid touching the black-plastic transfer belt or roller. Human skin oils on the belt or
roller can cause print-quality problems.
●
Do not let the transfer belt contact hard or sharp objects.
CAUTION: Scratches, punctures, or other damages to the belt will cause print-quality problems.
●
Make sure that the wire-harness is not twisted or pinched after it is passed through the opening in
the chassis and that the ITB sits flat in the product.
NOTE: When the toner-cartridge drawer is installed, it should easily slide in and out of the
product and not contact any part of the ITB assembly.
54 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...