3. When disassembling the ITB assembly (callout 1) make sure to release the cable (callout 2) from
the guide (callout 3).
CAUTION: The cable can be damaged if it is not released from the guide before the ITB is
removed from the chassis.
Figure 1-61 Remove the ITB (2 of 3)
3
1 2
3
4. Remove one screw (callout 1) and the stopper part (callout 2). Lift the ITB assembly (callout 3)
slightly by pushing up at the locations shown (callout 4) and then slide the ITB assembly out of the
chassis to remove.
Figure 1-62 Remove the ITB (3 of 3)
2
1 3
4
ENWW
Removal and replacement procedures
53
To Next Page
Loading...