Low-voltage power supply
CAUTION: Do not bend or fold the flat flexible cables (FFCs) during removal or installation. Also, do
not straighten pre-folds in the FFCs. You must make sure that all FFCs are fully seated in their
connectors. Failure to fully seat an FFC into a connector can cause a short circuit in a PCA.
1. Remove the following components:
●
Right cover. See
Right cover on page 15.
●
Left cover. See
Left cover on page 18.
●
Rear right cover. See
Rear right cover on page 21.
●
Rear door and rear lower cover. See
Rear door and rear lower cover on page 23.
2. Remove two screws (callout 1) and the fuser power supply cover (callout 2).
Figure 1-70 Remove the low-voltage power supply (1 of 3)
1
2
ENWW
Removal and replacement procedures
59
To Next Page
Loading...