3. On the Device Information page, the default printer name is in the Device Status field. You can change
this name to uniquely identify this printer.
NOTE: Completing the other fields on this page is optional.
4. Click the Apply button to save the changes.
Manually configure IPv4 TCP/IP parameters from the control panel
Use the control-panel menus to manually set an IPv4 address, subnet mask, and default gateway.
NOTE: The steps vary according to the type of control panel.
2-line control panels
1. On the printer control panel, press the OK button.
2. Open the following menus:
●
Network Setup
●
TCP/IP configuration
●
Manual
3. Use the arrow keys and the OK button to enter the IP address, subnet mask, and default gateway, and
then touch the OK button to save the changes.
Touchscreen control panels
1.
From the Home screen on the printer control panel, touch the Setup
button.
2. Open the following menus:
●
Network Setup
●
TCP/IP configuration
●
Manual
3. Use the keypad on the touchscreen to enter the IP address, and touch the OK button. Touch the Yes
button to confirm.
68 Chapter 5 Manage the product ENWW
To Next Page
Loading...