HP LaserJet Pro MFP M225 - Page 31

Input and output tray assemblies
Dust cover
Release two shafts (callout 1) and remove the dust cover (callout 2).
Figure 1-8 Remove the dust cover (1 of 1)
2
1
Input tray assembly
1. Remove the dust cover.
2. Pull the input tray assembly (callout 1) towards the front side of the printer and remove it.
Figure 1-9 Remove the input tray assembly (1 of 1)
1
Output tray assembly
Hold up the output tray assembly (callout 1) and remove it.
ENWW Removal and replacement procedures 11