HP LaserJet Pro MFP M225 - Page 35

Front cover assembly
Before proceeding, remove the following components:
●
Dust cover. See Dust cover on page 11
●
Input tray assembly. See Input tray assembly on page 11.
●
Output tray assembly. See Output tray assembly on page 11.
●
Left cover. See Left cover, duplex product on page 12 or Left cover, simplex product on page 13.
Remove the front cover assembly
1. Disconnect the FFC (callout 1).
Figure 1-16 Remove the front cover assembly (1 of 3)
1
ENWW Removal and replacement procedures 15