HP LaserJet Pro MFP M225 - Page 36

2. Remove one screw (callout 1) and the grounding cable (callout 2).
Figure 1-17 Remove the front cover assembly (2 of 3)
2
1
3. Remove one screw (callout 1), then release five tabs (callout 2) and remove the front cover assembly
(callout 3).
Figure 1-18 Remove the front cover assembly (3 of 3)
3
2
1
Right cover, duplex product
Before proceeding, remove the following components:
●
Dust cover. See Dust cover on page 11
●
Input tray assembly. See Input tray assembly on page 11.
●
Output tray assembly. See Output tray assembly on page 11.
16 Chapter 1 Removal and replacement ENWW