2. Remove four screws (callout 1), and then remove the duplex frame (callout 2).
Figure 1-25 Remove the duplex frame (2 of 2)
Rear cover, simplex product
Before proceeding, remove the following components:
●
Dust cover. See Dust cover on page 11
●
Input tray assembly. See Input tray assembly on page 11.
●
Output tray assembly. See Output tray assembly on page 11.
●
Left cover. See Left cover, simplex product on page 13.
●
Front cover assembly. See Front cover assembly on page 15.
●
Right cover. See Right cover, simplex product on page 18.
Remove the rear cover, simplex product
1. Release three tabs at the top of the cover (callout 1), and then release three tabs at the bottom of the
cover (callout 2).
22 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...