HP LaserJet Pro MFP M225 - Page 87

Figure 1-95 Remove the laser/scanner assembly (1 of 5)
1
2
2. Remove four screws (callout 1), and then remove the scanner cover (callout 2) and the sheet-metal
plate (callout 3) together.
CAUTION: The scanner cover (callout 2) and sheet-metal plate (callout 3) can be easily separated. Do
not lose the plate while servicing the product.
TIP: When the cover is reinstalled, make sure that the black screws (callout 4) are installed in the
correct screw holes.
Figure 1-96 Remove the laser/scanner assembly (2 of 5)
1
2
3
4
ENWW Removal and replacement procedures 67