HP LaserJet Pro MFP M225

Figure 1-93 Pressure release levers, LaserJet Pro M201 and M202 series
Figure 1-94 Pressure release levers, LaserJet Pro MFP M225 and M226 series
Reinstall the fuser film assembly
Content for this section was not provided.
Laser/scanner assembly
Before proceeding, remove the following components:
●
Dust cover. See Dust cover on page 11 or Dust cover on page 36
●
Input tray assembly. See Input tray assembly on page 11 or Input tray assembly on page 36.
●
Output tray assembly. See Output tray assembly on page 11 or Output tray assembly on page 37.
●
Left cover. See Left cover, duplex product on page 12 or Left cover, simplex product on page 13 or Left
cover on page 37.
●
Front cover assembly. See Front cover assembly on page 15 or Front cover assembly on page 38.
●
Right cover. See Right cover, duplex product on page 16 or Right cover, simplex product on page 18 or
Right cover on page 40.
Remove the laser/scanner assembly
1. Release one tab (callout 1), and then remove the holder (callout 2).
66 Chapter 1 Removal and replacement ENWW