3. If you are loading B4, A3, 11 x 17, Legal, or Oficio
8.5 x 13 size paper, unlock the rear tray guide
using the slide lock at the back of the tray.
4. Adjust the tray length to the correct paper size.
5. Load paper into the tray. Check the paper to
make sure the guides lightly touch the stack, but
do not bend the paper.
The way you should orient the paper in the tray
varies depending on the paper size. For
additional information, see
Tray 2 paper
orientation on page 21.
NOTE: To prevent jams, do not overfill the tray.
Be sure the top of the stack is below the tray full
indicator.
NOTE: If the tray is not adjusted correctly, an
error message might display during printing or
the paper might jam.
ENWW Load Tray 2 19
To Next Page
Loading...
