9. Close the print cartridge door.
NOTE: After closing the print cartridge door, the
Ready light and Attention light will ash.
Allow up to three minutes for the product to
calibrate.
NOTE: If replacing another print cartridge, you
must close the print cartridge door before
pressing the Cartridge button of the next print
cartridge.
You do not need to wait for the product to
calibrate when replacing the second print
cartridge. Instead, press the Cartridge button
for the next color to rotate the carousel into
position. After you have replaced the print
cartridges, the product calibrates.
NOTE: After every other black cartridge change,
a cleaning page prints automatically to clean the
fuser. This cleaning page process takes two
minutes to complete.
10. When printing, if you receive the status alert
message Wrong Cartridge in <Color> Slot,
remove the print cartridge from the specied slot
and compare the color label on the print cartridge
to the color label in the slot to determine the
correct print cartridge for the slot.
ENWW Manage supplies and accessories 87
To Next Page
Loading...