Connect to a network (network models only)
The product can connect to wired or wireless networks.
NOTE: You cannot connect to a wired and wireless network simultaneously. Wired connections take
precedence.
Supported network protocols
To connect a networking-equipped product to a network, you need a network that uses one of the following
protocols.
●
TCP/IP (IPv4 or IPv6)
●
Port 9100
●
LPR
●
DHCP
●
AutoIP
●
SNMP
●
Bonjour
●
SLP
●
WSD
●
NBNS
Install the product on a wired network
Congure the IP address
1. Connect the network cable to the product and to the network.
2. Wait for 60 seconds before continuing. During this time, the network recognizes the product and assigns
an IP addr
ess or host name for the product.
26 Chapter 4 Connect the product ENWW
To Next Page
Loading...