EasyManuals Logo

HP LP1965 User Manual

HP LP1965
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #49 background imageLoading...
Page #49 background image
ENWW
C Agency Regulatory Notices
Federal Communications Commission Notice
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that
are not expressly approved by Hewlett Packard Company may void the user's authority to operate
the equipment.
Cables
Connections to this device must be made with shielded cables with metallic RFI/EMI connector
hoods to maintain compliance with FCC Rules and Regulations.
Declaration of Conformity for Products Marked with the
FCC Logo (United States Only)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
Federal Communications Commission Notice 43

Table of Contents

Other manuals for HP LP1965

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP LP1965 and is the answer not in the manual?

HP LP1965 Specifications

General IconGeneral
Operating temperature (T-T)5 - 35 °C
Non-operating relative humidity (non-condensing)5 - 90 %
Pivot angle0 - 90 °
Plug and PlayYes
Tilt angle range-4 - 30 °
Height adjustment100 mm
Cable lock slot typeKensington
Panel mounting interface100 x 100 mm
3DNo
HD type-
Panel typeTFT
Pixel pitch0.294 x 0.294 mm
Aspect ratio4:3
Response time6 ms
Display surfaceMatt
Display diagonal19 \
Display resolution1280 x 1024 pixels
Display technologyLCD
Vertical scan range48 - 76 Hz
Horizontal scan range24 - 83 kHz
Contrast ratio (typical)1000:1
Display number of colors16.78 million colors
Display scanning frequencyHorizontal frequency: 24-83 kHz, Vertical frequency: 48-76 Hz
Display brightness (typical)300 cd/m²
Supported graphics resolutions1280 x 1024 (SXGA)
UNSPSC-code43211902
Audio includedNo audio included No audio included at platform level
Rear ports note4 USB 2.0
Native resolutionSXGA (1280x1024) pixels
Security featuresKensington Lock-ready
Weight (imperial)15.6 lb lbs
Power requirementsAuto-ranging, 90 to 265 VAC, Internal power supply, 50 to 60 Hz (built-in power supply)
Recommended resolutionPreset VESA Graphic Modes (non-interlaced): 1280 x 1024 @ 60 and 75 Hz, 1024 x 768 @ 60, 70 and 75 Hz, 1152 x 870 @ 75 Hz (Mac), 1152 x 900 @ 76 Hz (Sun), 832 x 624 @ 75 Hz (Mac), 800 x 600 @ 60, 72 and 75 Hz, 720 x 400 @ 70 Hz, 640 x 480 @ 60, 72 and 75
Display resolution at frequencyPreset VESA Graphic Modes (non-interlaced): 1280 x 1024 @ 60 and 75 Hz, 1024 x 768 @ 60, 70 and 75 Hz, 1152 x 870 @ 75 Hz (Mac), 1152 x 900 @ 76 Hz (Sun), 832 x 624 @ 75 Hz (Mac), 800 x 600 @ 60, 72 and 75 Hz, 720 x 400 @ 70 Hz, 640 x 480 @ 60, 72 and 75 Hz
Dimensions (W x D x H) (imperial)15.9 x 8.78 x 18.79 \
Product dimensions (without stand, imperial)15.9 x 2.4 x 12.96 \
Product colorBlack, Silver
Country of originChina
AC input voltage90 - 265 V
AC input frequency50 - 60 Hz
Power consumption (max)55 W
Power consumption (standby)2 W
Power consumption (typical)35 W
I/O portsOne upstream, four downstream ports (cable included)
USB hub version2.0
DVI-D ports quantity0
DVI-I ports quantity2
USB Type-A downstream ports quantity3
Cables includedAC, DVI
Interface adapters includedDVI-I female - VGA male
Weight and Dimensions IconWeight and Dimensions
Depth (with stand)222.9 mm
Width (with stand)403.9 mm
Height (with stand)377.2 mm
Weight (with stand)7060 g
Depth (without stand)61 mm
Height (without stand)329.1 mm
Weight (without stand)4190 g

Related product manuals