HP LP2475w User Manual

24" LCD Color Monitor HP LP2475w
49
Disconnect the
connector
remarked in
green to
remove LVDS
cable and the
cable which
connect panel
and power
board
Remove main
board and
power board
1.Remove the
screws
marked in red
to remove the
main board,
power baord,
2.Disconnect
the connector
and remove
the power
board and
main board.
The cable connected
panel and power
board
LVDS
Install：cable
should be under
the LVDS cable

HP LP2475w Specifications

General

3D	No
Pixel pitch	0.270 x 0.270 mm
Response time	6 ms
Display diagonal	24 \
Display resolution	1920 x 1200 pixels
Vertical scan range	48 - 85 Hz
Horizontal scan range	30 - 94 kHz
Contrast ratio (dynamic)	-
Contrast ratio (typical)	1000:1
Display brightness (typical)	400 cd/m²
Supported graphics resolutions	1920 x 1200 (WUXGA)
AC (power) in	Yes
USB hub version	2.0
DVI-D ports quantity	1
VGA (D-Sub) ports quantity	0
USB Type-A downstream ports quantity	6
LED indicators	Power
Tilt angle range	-5 - 30 °
Cable lock slot type	Kensington
Panel mounting interface	- mm
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	2 W
Power consumption (typical)	120 W
Product color	Gray
Country of origin	China
Storage temperature (T-T)	20 - 60 °C
Operating temperature (T-T)	5 - 35 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	20 - 80 %
Cables included	AC, DisplayPort, DVI, HDMI, USB

Weight and Dimensions

Depth (with stand)	253 mm
Width (with stand)	556.4 mm
Height (with stand)	421.6 mm
Depth (without stand)	83 mm
Width (without stand)	556 mm
Height (without stand)	362 mm
Weight (without stand)	9100 g