To Next PageTo Next Page
Need help?Do you have a question about the HP LTO-6 Ultrium FH SAS and is the answer not in the manual?
General| Storage Capacity (Native) | 2.5 TB |
|---|---|
| Storage Capacity (Compressed) | 6.25 TB |
| Data Transfer Rate (Native) | 160 MB/s |
| Data Transfer Rate (Compressed) | 400 MB/s |
| Interface | SAS |
| Buffer Size | 512 MB |
| Technology | LTO-6 Ultrium |
| Interface Speed | 6 Gb/s |
| Compatibility | LTO-6, LTO-5, LTO-4 |
| Warranty | 3 years |
Initial checks and prerequisites before installing an internal tape drive.
Specifies the physical bay and hardware needed for tape drive installation.
Instructions for safely opening the server chassis to access internal components.
Details on attaching rails or screws to secure the tape drive in the server bay.
How to verify and set the correct SCSI ID for internal tape drives.
Steps for physically inserting the tape drive into the server bay.
Procedures for connecting data and power cables to the tape drive.
Guidance on proper placement of SCSI terminators for bus integrity.
Final steps to ensure the tape drive is firmly fixed in place.
Steps for connecting external SCSI tape drives, including ID check and cabling.
Determining if termination is required for the external SCSI bus setup.
Steps for connecting external SAS tape drives and their power cables.
Specific marking requirements for Belarus, Kazakhstan, and Russia.
