1. 3mm mounting screws
2. Shoulder mounting screws
Figure 2 Attaching locating screws on a full-height drive
1. 3mm mounting screws
2. Shoulder mounting screws
Figure 3 Attaching locating screws on a half-height drive
SCSI internal tape drives — check the SCSI ID
The LTO tape drive is shipped with a default SCSI ID of 3. Each device on the SCSI bus must have a
unique SCSI ID number. The drive can be assigned any unused ID between 0 and 15. Do not use SCSI
ID 7, which is reserved for the SCSI controller. SCSI ID 0 is typically assigned to the boot disk and
should also not be used unless the tape drive is on a dedicated SCSI bus.
CAUTION: Static electricity can damage electronic components. Always wear an antistatic wriststrap
if possible. If not, to equalize the electromagnetic charges, touch a bare metal part of the server (such
as the back plate) before you remove the tape drive from its bag.
SCSI internal tape drives — check the SCSI ID 9
To Next Page
Loading...
