HP LTO-6 Ultrium FH SAS User Manual

5 Specifications and requirements
Table 1 Physical specifications for full-height drives
ExternalInternal
12.0 x 21.8 x 29.7 cm8.3 x 14.6 x 20.7 cmPhysical (HxWxD)
28 x 31 x 39 cm27.0 x 27.0 x 33 cmShipping (HxWxD)
5.57 kg2.24 kgWeight, out of box
7.3 kg3.6 kgWeight, shipping
Table 2 Physical specifications for half-height drives
ExternalInternal
12.0 x 21.8 x 29.7 cm4.1 x 14.5 x 20.6 cmPhysical (HxWxD)
24 x 31 x 39 cm24 x 31 x 39 cmShipping (HxWxD)
4.65 kg1.45 kgWeight, out of box
5 kg2.3 kgWeight, shipping
Table 3 Environmental specifications for LTO Ultrium tape drives
SpecificationCharacteristic
Temperature
10° to 35° C if 6 CFM airflow is providedOperating
10° to 40° C if 8 CFM airflow is provided for full-height drives, 5 CFM airflow is provided
for half-height drives
-40° to 66° CStorage
Humidity
20 to 80% RH (non-condensing, max wet bulb temperature = 26C)Operating
10 to 95% RH (non-condensing, max wet bulb temperature = 26C)Non-operating
Miscellaneous
4000 metersAltitude
less than 200 microgram / cubic meterDust concentration
Table 4 Power specifications for LTO Ultrium half-height tape drives
Ultrium LTO-3LTO-4 UltriumLTO-5 UltriumLTO-6 Ultrium
13 Watts idle13 Watts idle7.5 Watts idle4.5 Watts idle
(hibernate)
Power
consumption
20 Watts typical20 Watts typical24 Watts typical
29 Watts typical
(writing)
33 Watts maximum33 Watts maximum40 Watts maximum
42 Watts maximum
+5V @ 2.5A typical+5V @ 2.5A typical+5V @ 3.5A typical+5V @ 3.5A typicalPower
requirements
+5V @ 2.5A maximum+5V @ 2.5A maximum+5V @ 3.7A maximum+5V @ 4.0A maximum
+12V @ 0.7A typical+12V @ 0.7A typical+12V @ 0.7A typical+12V @ 0.6A typical
25

HP LTO-6 Ultrium FH SAS Specifications

General

Storage Capacity (Native)	2.5 TB
Storage Capacity (Compressed)	6.25 TB
Data Transfer Rate (Native)	160 MB/s
Data Transfer Rate (Compressed)	400 MB/s
Interface	SAS
Buffer Size	512 MB
Technology	LTO-6 Ultrium
Interface Speed	6 Gb/s
Compatibility	LTO-6, LTO-5, LTO-4
Warranty	3 years