NOTE The device automatically turns off and then on again to activate the update; this
can happen more than once. At the end of the update process, the READY message
appears on the control panel. Do not turn off the device or interfere with the update until you
see this message.
12. Print a configuration page and verify that the firmware revision number matches the revision of the
current update.
NOTE Print a menu map to see what features are available in the current firmware. Compare
this menu map with a menu map printed before the firmware update to determine what features
have been added or changed in the new firmware.
To print a menu map from the device control panel, see
Printing a menu map on page 82.
HP Web Jetadmin V7.8 and later can also be used to perform multiple or unattended installations.
Complete the following steps for multiple or unattended installations.
1. Start HP Web Jetadmin.
2. Create a device group. A simple way to do this is to follow these steps:
a. Click Device Management, and then click All Devices.
b. Shift-click to select devices that are to be included in the group, and then click OK.
c. When prompted, type a name for the new device group, and then click OK.
3. To modify several products in a group, click the group name, and then click Open.
4. The drop-down menu for Device Group Tools appears on the right side of the window. Scroll if
necessary to view it.
5. In the Device Group Tools drop-down box, select an action. Type the appropriate information.
Click Return to Device Group when finished.
ENWW Remote firmware updates 91
To Next Page
Loading...