ADF separation pad and pickup and feed roller assemblies (removal and
replacement)
NOTE Always replace the ADF separation pad and pickup and feed roller assemblies at the
same time.
1. Open the ADF cover and locate the ADF separation pad and pickup and feed roller assemblies.
Figure 5-4 Remove the ADF separation pad and pickup and feed roller assemblies (1 of 5)
2. Slightly raise the ADF input tray, release the ADF separation pad assembly latch, and remove the
assembly from the ADF.
Figure 5-5 Remove the ADF separation pad and pickup and feed roller assemblies (2 of 5)
184 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...