Tray 1 separation pad assembly (multipurpose pad assembly)
1. Open Tray 1.
2. Carefully pry the tray front retainer away from the tray arm and then pry the tray rear retainer (not
shown) away from the tray arm.
Tip When you reinstall the tray retainers, make sure that the inward facing pins are
inserted in the mounting holes in the sliding media adjustment shelf (callout 1).
1
Figure 5-13 Remove the Tray 1 separation pad assembly (1 of 3; front retainer shown)
3. Raise the top portion of the tray, and then remove one screw.
CAUTION Use a screwdriver with a magnetic tip so you do not drop this screw into the
device.
Figure 5-14 Remove the Tray 1 separation pad assembly (2 of 3)
ENWW User-replaceable parts 189
To Next Page
Loading...