3. Release the blue clip and slide the roller toward the front of the device. Rotate the rear of the roller
away from the device and then remove the roller. Install the replacement roller.
NOTE Installing the pickup rollers backwards will cause no-pick errors. Make sure that the
black shaft on the roller faces the front of the MFP when the rollers are installed.
Figure 5-18 Remove the Tray 2 and Tray 3 pickup rollers (3 of 4)
4. Reach up inside of the Tray 2 and Tray 3 cavity and release the blue latch on the upper pickup
roller. Slide the roller toward the clip and then rotate the roller out and away from the device.
Install the replacement roller.
NOTE The lower pickup roller was replaced through the right door in the previous step.
Figure 5-19 Remove the Tray 2 and Tray 3 pickup rollers (4 of 4)
192 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...