Jam cover
1. Open the ADF jam cover.
Figure 5-50 Remove the ADF jam cover (1 of 3)
2. Use a small flat-blade screw driver to rotate the retainer clip on the rear jam cover hinge pin until
the groove in the shaft is exposed (callout 1). Place the tip of a small flat-blade screwdriver in the
groove in the shaft and slide the shaft toward the back of the printer to release the cover (callout 2).
NOTE Be careful not to damage the spring or dislodge the retainer clip. Slightly closing
and opening the jam cover might make the shaft easier to move.
1
2
Figure 5-51 Remove the ADF jam cover (2 of 3)
ENWW ADF 211
To Next Page
Loading...