Scanner controller board (SCB) and cover
1. Use a small flat-blade screwdriver to carefully remove four adhesive caps (callout 1).
NOTE Do not damage the caps when you remove them. Do not excessively handle the
adhesive side of the caps. Skin oils will damage the adhesive on the back of the caps.
1
Figure 5-81 Remove the SCB (1 of 4)
2. Remove four screws (callout 2) and remove the cover.
2
Figure 5-82 Remove the SCB (2 of 4)
230 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...